CPP 1" Narrowed Control Arms For Coil Overs - 1988-1998 Chevy/GMC C1500

If you're running wider wheels and fighting tire rub against your control arms or coilover shocks, CPP's 1" Narrowed Control Arms are engineered specifically to solve that problem while giving you the correct mounting provisions for a coilover conversion.

Narrowing the track width by an inch on each side gives serious clearance for wider wheel and tire combinations that would otherwise rub against a stock-width control arm, especially once you factor in the offset changes that come with a lot of popular aftermarket wheel choices. This is a common pain point for OBS truck owners chasing a more aggressive wheel fitment, and CPP addresses it directly rather than leaving you to fabricate spacers or narrow arms yourself.

These arms are also built specifically to accept coilover shocks, meaning the spring perch and shock mounting geometry is correct from the factory rather than requiring you to adapt a standard control arm after the fact. If you're planning a coilover conversion and want wider wheel clearance handled in the same upgrade, this is a smart way to knock out two problems with one control arm swap.

CPP builds these to their usual standard for classic truck suspension components - solid construction that installs without drama using factory-style mounting points. This keeps the job in bolt-on territory rather than requiring narrowing fabrication work on your existing arms.

Installation uses your factory upper control arm mounting points for a straightforward swap, though as always, get a proper alignment once your front end work is complete, especially given the track width change.

Fits: Chevrolet C1500 2WD 1988-1998.

CPP Part #: 8898TCA-ULK-B-COK

Pairing this with a coilover kit? Check out our CPP Front Coil Over Kit listings to complete the setup.